AirPulse A200 Active Bookshelf Bluetooth Speaker System with Signature Phil Jones Design - Cherry Wood

Product Information

Moreover flat speakers do not sound the best for human ears, and that is why headphones with harman kardon curve for example may sound better than flat ones. I was impressed with the sound quality, not really a ‘High-End HiFi’ sound but much, much better than one would expect from Bluetooth speakers. Diagram 3: The LF frequency response, measured close to the woofer, with the port open (orange) and blocked (purple). The A300 organ-pipe resonance is a potentially audible one, however, because its peak is only around 5dB below the fundamental port output.

The 65Hz bump is a bit of a mystery but it may well contribute to the A300's subjective bass performance. They are housed in an 18-mm thick high-strength MDF cabinet finished with attractive piano black(or red) lacquer. Few recent review monitors have had me reaching for so many little-played CDs and old mixes just to "see what it sounds like", but at the same time, I was never entirely comfortable with the A300's bass character, or its quirks — that DIN cable in particular. It also features an under-hung motor structure and a high-power neodymium motor for better bass and less distortion.The reason for doing this is probably that it makes implementation of the A300's Bluetooth connectivity easier.

Those inputs are routed internally, via DSP‑implemented crossover filters, to Class‑D power amplification rated at 70 Watts for the bass/mid driver and just 10 Watts for the tweeter. Moreover, the USB digital audio interface supports UAC2 digital audio and comes with an ASIO audio drive to allow Windows users to access high-quality and low-latency signal output. I wanted the upper mids to be extended, I wanted to be aware of the subtleties of this piece, the vocal nuances and the extended reverb tails from the percussive cymbals but I didn’t hear any of that from the A80s. I'm only listening near field as a computer setup, the speaker positioning is already not great (close to a wall), but listening near field kind of fixes that problem a little.So you can start with 80 Hz and then try 70 Hz, if you consider that the speakers sound better with 70 Hz crossover do that It will obviously be less overlapping. That sound became ingrained into my memory and later in life when I worked as a recording and live sound engineer, it became an invaluable asset on how to engineer sound that was dynamic, full-range, and transparent.

Also included are a pair of high-density foam ‘wedge’ stands – these would be very useful if using the speakers on a desk so they fire up towards ear level. Enjoy our highest quality 3-dimensional sound and reduce the impact of room reflected sound in your audio. The PB-2000 Pro can’t be pushed that far past 5% THD above 20Hz even at the absolute maximum drive level.

compatible via a Qualcomm chipset and supports codecs up to aptX with an input sample rate of up to 192 kHz. The measured performance here is fine, although SVS subs that I have tested in the past tended to have less distortion than what either of these subs could be pushed to. But, I will say that as far as negatives go, they’re really quite minimal when stacked up against every good quality the P100X has going for itself. Using the same XMOS core as its older siblings, this unassumingly basic cabinet delivers outstanding performance beyond expectations. They sounded good, but there was some kind of weird whining sound coming from them both when music was played on Roon (Qobuz) using USB (didn't test spotify).