About this deal
SAFETY CAUTION: This project includes a Lithium Battery. This project should not be left unattended while operating or unattended while charging. Lithium batteries can overheat and cause personal injury and/or fire and death. If the battery gets hot it can be disconnected by cutting the foil battery tabs with scissors. Try to avoid shorting the foil tabs of the battery together with the scissors while cutting. The one side of the blue LED goes to the battery (+) bus through a 330 ohm resistor. The negative LED connection goes to pin 7 of the integrated circuit as shown in the modification photo. Follow the modification photo to cut the appropriate trace to disconnect the blue LED and solder the negative Green LED wire to pin 7 and the positive Green LED wire to the battery (+) bus through a 330 ohm resistor, scraping off the green solder resist to expose bare copper. The nice thing about the pedestal I chose is that it has a hollow center. All I had to do was put a hole in one side and another in the top. The first picture shows my basic plan on how I will connect the piping. The Transducer Disk is positioned behind the Disk Mount with the Disk center and solder joints lining up with the appropriate holes.
Electronic Atomizer Circuit Board with Battery [ AliExpress: "2022 New Ultrasonic Mist Maker Fogger Ceramics Discs Replacement with PCB for atomizer"]
Lurch's Apple Pie Mocktail
ounce plastic container. This was a takeout container that we had after buying miso soup from a Japanese Restaurant. Should be easy to find something similar. Just make sure it is flexible and you can cut it. The hardest part about this was finding the dry ice in the grocery store. Tip: Ask at the front. The effect was super cool and the punch is so tasty. ~Annabelle
The splashing was a big problem in my eyes. It was frustrating that the surface of the table that the cauldron was sitting on would become soaked after a few minutes of running. I tried putting more water into the cauldron thinking that it wouldn’t splash so much but this assumption was wrong. It seemed to splash even more with more water. I then tried only filling the cauldron up to the minimum line. This definitely helped but did not eliminate the problem completely. You should be able to get all the hardware supplies including the magnets, paint, tape and PVC couplings at the hardware store) These sensory elements create spectacle, but the depth of flavor the smoke creates delivers satisfaction. Different factors can influence the direction these flavors take, starting with the choice of wood. For example, the Macallan barrel staves used to create Zuma’s Burning History — a riff on the Penicillin — imbue a nuanced fruity essence into the smoke. Other ingredients can also add complexity to smoke, such as dried herbs like rosemary and thyme.I made a hole 2" in diameter and 3" above the bottom of the pedestal in one side. It does not really need to be a super neat...You just need it big enough to get your pipe in. !!!Before you drill!!! Measure your smoke machine from the middle of the smoker hole, to the bottom of the machine. In my case, it was 3". So that is is how I determined how high up the center of the hole would be.