Can anyone comment on this please. I’ve been carefully studying FTTP option as we have been offered FTTP (up to 900 down by BT, I’m likely to go for 150 down, and needing a much faster upload speed soon) at our home. Poles in the lane about half mile from fibre cabinet) have carried OR fibre for a couple of years but now being marketed for our postcode. After reading this excellent review, I’ve understood that if fibre line is now routed from the nearest pole about 35 metres away from which the current ADSL line runs to our eaves outside it would replace the current BT ADSL broadband (only 4 down, minimal up) and phone.

Of course the van supplier will allow me to do a test now and then which will shows that indeed the engine runs at 500mph and I’ll feel good. Then I’ll take the kid to school at 50mph feeling good that someday it might be 500mph. You must always plug your Hub into the Openreach modem port PORT 1. If you're connected to PORT 1 but have no internet connection, try plugging the Ethernet cable (red ends) into the next one along. After a few minutes a blue light will show your Hub is ready. I know that others here have answered the technical aspects of your query @Marty3, just hoped the jargon stuff might be helpful. There are too many variables that affect speed such as quality of home wiring and wifi equipment quality etc. Even BT on their community forums admit that they have now reached the point where they are offering speeds which are too fast for the majority customer in-home infrastructure to handle.It’s like buying a Formula 1 Van to do the school run, of course it will go the stated speed of 500mph or whatever but the local quality of roads don’t allow it etc etc. Not sure why the alternative has to be something PoE capable. The existing has worked fine for a few hundred thousand installs. Something for consideration in the future as I’ve said but I can’t see either SFP or wires-only being a thing unless plugging the fibre into an Openreach approved router that they are able to provision. If you're having trouble with your broadband speed the device you’re using could be the cause of the slow speed. If possible try using another device to see if you’re having a similar problem on that one too. You're not alone in not understanding what it all means. I eventually looked up lots of the terms and made a post ("Technical Jargon") at https://community.plus.net/t5/Tech-Help-Software-Hardware-etc/Technical-Jargon/m-p/1919108/highlight... .

From there, a much smaller cable will be run inside to a small, powered, wall-mounted unit that we’ll plug your router into. Finally, we’ll test your full fibre connection on one of your preferred devices to make sure you’re totally happy, so you can start making the most of a faster, more dependable connection than ever. I don’t think it will be too long before Trading Standards are involved in these ISP speed declarations.This ONT will likely contain the same circuit board as Nokia’s other router/Wi-Fi combined units, just with a lot of the PCB left empty, this is standard practice these days to reduce costs, use the the same BOM where you can and just leave stuff off not required, unless it works out cheaper to produce a smaller PCB due to the cost of the PCB itself and if quantities warrant it. Common-sense says a single port is more expensive if they are only making them for BT Openreach and the rest of the world is taking more 4 port models and/or they have a standard design to reduce costs.